414 guides across 21 subjects
Every figure traced to a named source
Prices in Ugandan shillings, per acre and per animal

Acre to Hectare Conversion for Farmers

Farmland divided into fields, seen from the air

Ugandan land is bought, rented and talked about in acres. Agronomic recommendations, research results and most fertiliser and seed rates are published per hectare. Every season that gap produces fields given roughly two and a half times what was intended, or two fifths of it, and the arithmetic that caused it was never written down.

The conversions

From To Multiply by
Acres Hectares 0.405
Hectares Acres 2.471
Acres Square metres 4,047
Hectares Square metres 10,000
Square metres Acres divide by 4,047

One acre is 4,047 square metres, which is a square of about 64 metres a side. One hectare is 10,000 square metres, a square of 100 metres a side, and holds about two and a half acres.

Convert the rate too, and in the right direction

This is where the error lives. An area and a rate convert in opposite directions, and the instinct is to convert both the same way.

If a recommendation is per hectare and your field is in acres, you need less per acre, because an acre is smaller. Multiply the rate by 0.405.

A rate of 100 kg per hectare is about 40 kg per acre. Applying 100 kg to an acre delivers roughly 247 kg per hectare, two and a half times the recommendation.

Going the other way, a rate quoted per acre applied across a hectare needs multiplying by 2.471.

Worked examples

Fertiliser. 130 kg of urea per hectare is 130 multiplied by 0.405, about 53 kg per acre, which is just over one 50 kg bag. The full nutrient-to-product sum is in how to calculate fertiliser requirements.

Seed. 25 kg per hectare is about 10 kg per acre. See how to calculate seed rate per acre.

Yield. A yield of 2.2 tonnes per hectare is 2.2 multiplied by 0.405, about 0.89 tonnes, or 890 kg, per acre. Yields quoted per hectare look far better than the same crop quoted per acre, which is worth remembering when comparing two sources.

Plant population. 44,400 plants per hectare is about 18,000 per acre. The sum is in how to calculate plant population per acre.

A check that catches most mistakes

If a converted figure is about two and a half times bigger or smaller than it should be, a unit was mixed. That ratio is the signature of this particular error, and it is worth looking for before accepting any converted number that feels surprising.

The habit that prevents it: write the unit next to every figure, every time, and write the converted acre figure directly onto the recommendation sheet so the conversion is done once rather than remembered under pressure at the store.

Local measures

Land described in gardens, plots or paces is not an area until it has been measured. A plot is not a standard size, and a pace varies with who is pacing. Before any rate is applied, measure the ground: length multiplied by width in metres gives square metres, and dividing by 4,047 gives acres. For irregular shapes, split the field into rectangles and triangles, work each one out and add them.

Doing this once, properly, and writing the figure down is worth more than any calculation performed on an assumed area. Every per-acre number on the farm depends on it: see the farm record keeping guide.

Frequently Asked Questions

How many acres are in a hectare? About 2.471. Going the other way, one acre is about 0.405 hectares. In square metres, an acre is 4,047 and a hectare is 10,000.

If a rate is given per hectare, do I apply more or less per acre? Less. An acre is smaller than a hectare, so it needs about 0.405 of the hectare rate. Applying the hectare figure to an acre delivers roughly two and a half times too much, which is expensive with fertiliser and dangerous with agrochemicals.

How big is an acre on the ground? 4,047 square metres, which is a square of roughly 64 metres a side. A football pitch is a useful comparison: a full-size one is a little larger than an acre and a half.

How do I measure an irregular field? Divide it into rectangles and triangles, measure each in metres, work out the area of each, and add them. A rectangle is length times width; a triangle is half the base times the height. Divide the total square metres by 4,047 for acres.

Why do yields per hectare look so much better than per acre? Because a hectare is nearly two and a half times the area, so the same crop produces a much larger number. Two tonnes per hectare and two tonnes per acre describe very different performances. Always check which unit a published yield is in before comparing it with your own.

More in Farm Calculators and Record Templates